Table of Contents
Advertisement
4 — Configuring generic node parameters
Configuring the destination IP address
The destination IP address is the IP address of the remote host.
Procedure 4-7 Configuring the
HOUSE — MORE — IP_ADDRESSES — DESTIP — <ipaddress>
where ipaddress is the IP address of the gateway in the decimal format #.#.#.# and where
# is in the range 0 to 255
Configuring the subnet mask
The subnet mask for the domain containing the Speed Touch 591s must be
configured manually when the Speed Touch 591s is operating with a 7300 ASAM.
Procedure 4-8 Configuring the
HOUSE — MORE — IP_ADDRESSES — SUBNET_MASK — <mask>
where mask is the subnet mask in the decimal format #.#.#.# and where # is in the range
0 to 255
Configuring the control VP/VC
The VP/VC used to carry management signals can be configured manually when the
Speed Touch 591s is operating with a 7300 ASAM, because the 7300 ASAM does
not support CPSS signals.
4-6
The new IP address is not applied until the control IP
Note —
address, subnet mask, and control VP/VC have been correctly
configured individually, and the configuration has been applied
globally—see procedure 4-10.
Note —
The new mask is not applied until the control IP address,
destination IP address, and control VP/VC have been correctly
configured individually, and the configuration has been applied
globally—see procedure 4-10.
The new control VP/VC is not applied until the control IP
Note —
address, destination IP address, and subnet mask have been correctly
configured individually, and the configuration has been applied
globally—see procedure 4-10.
destination IP address
subnet mask
Speed Touch 591s Technical Practices
90-8785-01
February 2001
Advertisement
Table of Contents
