Table of Contents
Advertisement
Procedure 3-2 Installing the Speed Touch 591s
1
Plug in the power supply to the power outlet on the Speed Touch 591s.
2
Plug in the power supply to an electrical outlet.
3
Plug the network cable into the network port.
4
Clip the ferrite bead around the network cable as close to the network connector as
possible; see Figure 3-1.
Speed Touch 591s Technical Practices
February 2001
90-8785-01
Figure 3-1 Attaching the ferrite bead
Ferrite bead
Network cable
3 — Installation
Network connector
14432
3-5
Advertisement
Table of Contents
