Table of Contents
Advertisement
10 — Configuring the T1/E1 CE port
Procedure 10-12 Configuring the data path for trunk conditioning
1
Enter:
CONFIG — OBJECT — PORT — <U>
2
Specify the channel or channels.
a
b
c
3
Select:
DATA
4
Select the bit pattern for the data path.
a
b
c
10-16
For a single channel, enter:
<channel_id>
where channel_id is a number from 1 to 24 for a T1 CE port and 1 to 31 for an E1
CE port
For a channel group, enter:
<CGnumber>
where number is the lowest numbered channel in a channel group
For a channel range, enter:
<n1-n2>
where
n1 is the first channel in the range in the CH column
n2 is the last channel in the range in the CH column
For a custom bit pattern, enter:
CUSTOM — <data>
where data is an 8-character bit pattern
To transmit a signal that indicates that the multiplexer is out of service, select:
MUX_OOS
To transmit a signal that indicates a fault on the upstream device, select:
IDLE
— TRUNK_COND
Speed Touch 591s Technical Practices
90-8785-01
February 2001
Advertisement
Table of Contents
