Table of Contents
Advertisement
Configuring the DSLAM type
The Speed Touch 591s can be configured to be compatible with either of two types
of DSLAM—DSLAMs that support CPSS or DSLAMs that do not support CPSS.
If the Speed Touch 591s is connected to a 7350 ASAM, configure the DSLAM type
as 7350. If the Speed Touch 591s is connected to a 7300 ASAM or any other
DSLAM, configure the DSLAM type as 7300.
Procedure 4-5 Configuring the DSLAM type
HOUSE — MORE — DSLAM_TYPE — 7350* or 7300
Configuring the control IP address
The control IP address is the IP address of the Speed Touch 591s. It can be
configured manually when the Speed Touch 591s is operating with a 7300 ASAM.
Procedure 4-6 Configuring the
HOUSE — MORE — IP_ADDRESSES — CTLIP — <ipaddress>
where ipaddress is the IP address of the Speed Touch 591s in the decimal format #.#.#.#
and where # is in the range 0 to 255
Speed Touch 591s Technical Practices
February 2001
90-8785-01
Note —
Configuration of this parameter does not affect SHDSL
interoperability—it only specifies how the Speed Touch 591s
communicates with the DSLAM for management purposes.
Note —
The new IP address is not applied until the destination IP
address, subnet mask, and control VP/VC have been correctly
configured individually, and the configuration has been applied
globally—see procedure 4-10.
4 — Configuring generic node parameters
control IP address
4-5
Advertisement
Table of Contents
