Factory Default - Planet IGS-10020MT User Manual

4.2.21 Factory Default

You can reset the configuration of the stack switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the web main page without resetting the configuration.
After the "Factory" button be pressed and rebooted, the system will load the default IP settings as following:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the Industrial Managed Switch to the Factory default setting, you can also press the hardware
reset button at the front panel about 5 seconds. After the device be rebooted. You can login the
management WEB interface within the same subnet of 192.168.0.xx.
Hardware Reset button
Figure 4-2-32: Factory Default Page Screenshot
Figure 4-2-33: Factory Default Page Screenshot
84
User's Manual of IGS-10020MT
Figure 4-2-32 appears.