Install The Industrial Managed Switch; Installation Steps - Planet IGS-10020MT User Manual

2.2 Install the Industrial Managed Switch

This section describes how to install your Industrial Managed Switch and make connections to the Industrial Managed
Switch. Please read the following topics and perform the procedures in the order being presented. To install your Industrial
Managed Switch on a desktop or shelf, simply complete the following steps.
In this paragraph, we will describe how to install the Industrial Managed Switch and the installation points attended to it.

2.2.1 Installation Steps

1. Unpack the Industrial Managed Switch
2.
Check if the DIN-Rail is screwed on the Industrial Managed Switch or
Industrial Managed Switch, please refer to DIN-Rail Mounting section for DIN-Rail installation. If users want to wall
mount the Industrial Managed Switch, please refer to Wall Mount Plate Mounting section for wall mount plate
installation.
3. To hang the Industrial Managed Switch on the DIN-Rail track or wall.
4. Power on the Industrial Managed
information about how to wire the power. The power LED on the Industrial Managed Switch will light up. Please refer to
the LED Indicators section for indication of LED lights.
5. Prepare the twisted-pair, straight through Category 5 cable for Ethernet
6. Insert one side of RJ-45 cable (category 5) into the Industrial Managed Switch Ethernet port
side of RJ-45 cable (category 5) to the network device's Ethernet port (RJ-45 port), ex: Switch PC or Server. The UTP port
(RJ-45) LED on the Industrial Managed Switch will light up when the cable is connected with the network device. Please
refer to the LED Indicators section for LED light indication.
Make sure that the connected network devices support MDI/MDI-X. If it does not support,
use the crossover category-5 cable.
7. When all connections are set and LED lights all show in normal, the installation is complete.
Switch. Please refer to the Wiring the Power Inputs section for knowing the
33
User's Manual of IGS-10020MT
not. If the DIN-Rail is not screwed on the
connection.
(RJ-45 port) and another