Planet IGS-10020MT User Manual page 40

SFP-Port 1000Base-SX mini-GBIC module - 550m (-40~75℃)
MGB-TSX
SFP-Port 1000Base-LX mini-GBIC module - 10km (-40~75℃)
MGB-TLX
SFP-Port 1000Base-LX mini-GBIC module - 30km (-40~75℃)
MGB-TL30
SFP-Port 1000Base-LX mini-GBIC module - 70km (-40~75℃)
MGB-TL70
Fast Ethernet SFP Transceiver Modules
SFP-Port 100Base-FX Transceiver (1310nm)-2km
MFB-FX
SFP-Port 100Base-FX Transceiver (1310nm)-20km
MFB-F20
SFP-Port 100Base-FX Transceiver (1310nm)-40km
MFB-F40
SFP-Port 100Base-FX Transceiver (1310nm)-60km
MFB-F60
SFP-Port 100Base-BX Transceiver (WDM,TX:1310nm)-20km
MFB-FA20
SFP-Port 100Base-BX Transceiver (WDM,TX:1550nm)-20km
MFB-FB20
SFP-Port 100Base-FX Transceiver (1310nm) -2km (-40~75 )
MFB-TFX
SFP-Port 100Base-FX Transceiver (1310nm) - 20km (-40~75℃)
MFB-TF20
It recommends using PLANET SFPs on the Industrial Managed Switch. If you insert a SFP
transceiver that is not supported, the Industrial Managed Switch will not recognize it.
1000Base-SX/LX:
Before connect the other switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
 To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable- with one side must be male duplex LC
connector type.
 To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must be male duplex LC
connector type.
Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Industrial Managed Switch. Ensure that the SFP transceiver
is operating correctly.
100Base-FX:
Before connect the other switches, workstation or Media Converter.
℃
40
User's Manual of IGS-10020MT