Table of Contents
Advertisement
OSD -
MOTION SETUP
1
MOTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PRESET LOCK
PWR UP ACTION
AUTO FLIP
JOG MAX SPEED
JOG DIRECTION
FRZ IN PRESET
<PARKING ACTION SETUP>
<ALARM INPUT SETUP>
BACK
EXIT
2
PARKING ACTION SETUP
- - - - - - - - - - - - - - - - - - - - - - - - - - -
PARK ENABLE
WAIT TIME
PARK ACTION
BACK
EXIT
1
Configures the general functions of pan/tilt motions.
OFF
ON
PRESET LOCK
ON
If motion lock is set to ON, it will be impossible to setup or delete a
1 40/SEC
preset, scan, pattern, and/or group. It will only be possible to run
NORMAL
OFF
those functions. To setup and delete those functions, go to OSD
menu.
PWR UP ACTION
This function enables you to resume the last action executed before
the power went down. Most actions such as preset, pattern, scan,
Press
and group resume for this function, but jog action does not resume
Near/Enter
with this function.
Key
AUTO FLIP
When the tilt angle arrives to the top of tilt orbit (90°), zoom module
camera continues moving opposite of the tilt direction (180°) to continue
OFF
tracing targets. As soon as zoom module camera passes through the
00: 1 0:00
top of the tilt direction (90°), images should be reversed automatically
HOME
and F
range is 0° ~ 90°.
JOG MAX SPEED
Sets maximum jog speed. Jog speed is inversely proportional to
zoom magnification. As zoom magnification goes up, pan/tilt speed
goes down.
JOG DIRECTION
If you set this to NORMAL, the view on the screen is moving in the
same direction with jog tilting. If INVERSE is selected, the view on
the screen is moving reversely.
FRZ IN PRESET
When present movement begins, the camera captures the image of
the beginning point. Camera will display the captured image during
the present movement and will not display the images the camera
receives during the movement. As soon as the camera stops at the
preset end point, the camera begins to display the live images it
receives at the end point.
<PARKING ACTION SETUP>
Opens PARKING ACTION SETUP screen.
<ALARM INPUT SETUP>
Opens ALARM INPUT ACTION screen.
2
If PARK ENABLE is set to ON, camera runs assigned function
automatically if there is no PTZ command during assigned
WAIT TIME.
PARK ENABLE
WAIT TIME
The time is displayed in "HH:MM:SS" format, and the time can be
changed by 1 second unit.
1. To place the cursor on the time marked as shown below, press
2. Move joystick left/right to adjust hours, minutes and seconds.
3. Move joystick up/down to select the digit.
4. By pressing Near key, save the current setting.
PARKING ACTION
Ex. If HOME is selected for park action, camera will move to home
position when there is no PTZ command during the assigned
WAIT TIME.
MOTION SETUP
ON / OFF
ON / OFF
ON / OFF
appears on the screen. If this function is set to OFF, tilt movement
2/SEC ~ 200/SEC
INVERSE / NORMAL
ON / OFF
PARKING ACTION SETUP
ON / OFF
00:00:05 ~ 04:00:00
Near key.
00:10:00
HOME / PRESET 1~128 / SCAN 1~8 /
PATTERN 1~4 / GROUP 1~8
24
Advertisement
Table of Contents
