Part Names - InFocus IN5122 User Manual

Introduction

Part names

Projector
(1) Lamp cover ( 82)
The lamp unit is inside.
(2) Speakers (x2) (13, 41)
(3) Filter cover (86)
The air filter and intake vent are inside.
(4) Elevator feet (x2) (20)
(5) Elevator buttons (x2) (20)
(6) Remote sensor (15)
(7) Lens (86)
(8) Lens cover
(9) Intake vents
(10) Control panel (5)
(11) Lens adjuster door (5)
The adjusters for the lens are behind
the door.
(12) AC IN (AC inlet) (14)
(13) Exhaust vent
(14) Rear panel (5)
(15) Security bar (14)
(16) Heel
WARNING
manuals direct it.
►Do not subject the projector to unstable conditions.
►Do not shock or apply pressure to this product.
►Do not look into the lens or openings of the projector when the lamp is on.
►Keep the lens cap away from children and pets. Make sure they do not
swallow the caps. If swallowed consult a physician immediately for emergency
treatment.
CAUTION
cover or the exhaust vents during use or just after use, since it is too hot.
►Do not attach anything onto the lens except the projector's lens cover
because it could melt or otherwise damage the lens.
(continued on next page)
4
►Do not open or remove any portion of the product, unless the
►Do not touch the projector anywhere around the lamp