OPTION menu
Item
SERVICE
(continued)
(continued on next page)
54
COMMUNICATION TYPE
Select the communication type for transmission via
the CONTROL port.
NETWORK BRIDGE: Select this type, if you will be
OFF: Select this mode to receive RS-232C
• The default setting is OFF.
• When you select NETWORK BRIDGE, also
check TRANSMISSION METHOD (below).
SERIAL SETTINGS
Select the serial communication condition for the
CONTROL port.
BAUD RATE
COMMUNICATION
(continued)
• When the COMMUNICATION TYPE is set to OFF,
the BAUD RATE is set to 19200bps and PARITY is
set to NONE (above).
TRANSMISSION METHOD
Select the communication transmission method used
by the NETWORK BRIDGE through the CONTROL
port.
HALF-DUPLEX: This method allows the projector
FULL-DUPLEX: This method allows the projector
• HALF-DUPLEX is the default setting.
• If you select HALF-DUPLEX, also check the
RESPONSE LIMIT TIME (55).
Description
NETWORK BRIDGE ó OFF
controlling an external device from a computer via
this projector.
The CONTROL port does not accept RS-232C
commands (Network Bridge in the Network
Guide)
commands through the CONTROL port.
4800bps ó 9600bps ó 19200bps ó 38400bps
PARITY
NONE ó ODD ó EVEN
HALF-DUPLEX ó FULL-DUPLEX
to communicate both ways, however only one
direction, either transmitting or receiving data, is
allowed at a time.
to communicate both ways, transmitting and
receiving data simultaneously.