Regarding The Indicator Lamps - InFocus IN5122 User Manual

Regarding the indicator lamps

When the LAMP, TEMP and POWER indicator operate differently than usual,
follow the instructions below in the following table.
For the SECURITY indicator, see SECURITY INDICATOR in the SECURITY menu.
POWER LAMP
indicator indicator
Solid Turned
Orange off
Blinking Turned
Green off
Solid Turned
Green off
Blinking Turned
Orange off
Blinking (discre-
tionary)
Red
Blinking
Red
Solid
or
Red
Solid
Red
Blinking
Red
Blinking
or
In
Red
Solid
Red
Blinking
Red
Turned
or
off
Solid
Red
TEMP
indicator
Turned
The projector is in a standby state.
Please refer to the section "Power on and off".
off
Turned
The projector is warming up.
Please wait.
off
Turned
The projector is in an on state.
Ordinary functions can be performed.
off
Turned
The projector is cooling down.
Please wait.
off
The projector is cooling down. An error has
(discre-
been detected.
tionary) Please wait until POWER indicator finishes blinking,
and then follow the associated instructions below.
The lamp will not light, and the projector may be
overheating.
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
sufficiently cooled down, please confirm the following
Turned
items, and then turn the power on again.
• Are the air vents blocked?
off
• Is the air filter dirty?
• Is the room temperature higher than 95°F (35°C)?
If the same indicator re-appears after fixing the above,
please change the lamp referring to the section
Replacing the lamp.
The lamp cover has not been properly fixed.
Please turn the power off, and allow the projector
to cool down at least 45 minutes. After the projector
Turned has sufficiently cooled down, please verify that the
lamp cover is securely and properly fastened. After
off
performing any needed maintenance, turn the power on
again. If the same indicator re-appears after fixing the
above, please contact your dealer or service company.
The cooling fan is not operating.
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
Blinking
sufficiently cooled down, please confirm that no foreign
matter has become caught in the fan, etc., and then
Red
turn the power on again.
If the same indicator re-appears after fixing the above,
please contact your dealer or service company.
Troubleshooting
Description
89