Network Menu - InFocus IN5122 User Manual

NETWORK menu

Remember that incorrect network settings on this
projector may create problems on your network. Be
sure to consult with your network administrator before
connecting to an existing access point on your network.
Select "NETWORK" from the main menu to access the
following features.
Highlight an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button on the projector or
remote control, or SELECT button on the remote control to select the item. Then
make adjustments per the following table.
Refer to the Network Guide for NETWORK operation details.
NOTE
• If you are not utilizing SNTP (Date/Time Settings in the Network
Guide), then you must set the DATE AND TIME during initial installation.
• If POWER SAVING MODE is set to ENABLE in the SETUP menu, network
communication control will be disabled when the projector is in power saving
mode. To avoid this, set the POWER SAVING MODE to DISABLE (40) before
setting up network communication control.
Item
SETUP
(continued on next page)
Selecting this item displays the SETUP
menu for the network.
Use the ▲/▼ buttons to highlight an item,
and the ► or SELECT button on the remote
control to select the item.
Use the ▲/▼ buttons to turn DHCP on and off.
Select DISABLE when the network is not DHCP
enabled.
DHCP
(Dynamic Host
• When "DHCP" is set to "ENABLE", it takes a
Configuration
little time to obtain an IP address from the DHCP
Protocol)
server.
• The Auto IP feature will assign an IP address if
the projector cannot obtain an IP address from the
server (even if DHCP is "ENABLE").
Description
ENABLE ó DISABLE
NETWORK menu
57