Ipv6 Static Route Edit - ZyXEL Communications AMG1302-T series User Manual

Chapter 9 Static Route
Table 38 Network Setting > Static Route > IPv6 Static Route
LABEL
Destination
Prefix Length
Device
Modify

9.3.1 IPv6 Static Route Edit

Use this screen to configure the required information for an IPv6 static route. Click Add new static
route or select an IPv6 static route index number and click Edit. The screen shown next appears.
Figure 58 Network Setting > Static Route > IPv6 Static Route: Add/Edit
The following table describes the labels in this screen.
Table 39 Network Setting > Static Route > IPv6 Static Route: Add/Edit
LABEL
Destination IPv6
Address
IPv6 Prefix Length Enter the address prefix to specify how many most significant bits compose the network
PVC IPv6 Address
OK
Cancel
138
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
An IPv6 prefix length specifies how many most significant bits (starting from the left) in
the address compose the network address. This field displays the bit number of the IPv6
subnet mask.
This specifies the LAN or WAN PVC.
Click the Edit icon to go to the screen where you can set up a static route on the
AMG1302/AMG1202-TSeries.
Click the Remove icon to remove a static route from the AMG1302/AMG1202-TSeries. A
window displays asking you to confirm that you want to delete the route.
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a prefix
length of 128 in the prefix length field to force the network number to be identical to the
host ID.
address.
Select the interface through which the traffic is routed.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302/AMG1202-TSeries User's Guide