Ipv6 Static Route - ZyXEL Communications AMG1302-T series User Manual

Figure 56 Network Setting > Static Route Add/Edit
The following table describes the labels in this screen.
Table 37 Network Setting > Static Route Add/Edit
LABEL
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
OK
Cancel

9.3 IPv6 Static Route

Use this screen to view the IPv6 static route rules. Click Network Setting > Static Route > IPv6
Static Route to open the IPv6 Static Route screen.
Figure 57 Network Setting > Static Route > IPv6 Static Route
The following table describes the labels in this screen.
Table 38 Network Setting > Static Route > IPv6 Static Route
LABEL
Add new static
route
#
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Enter the number of transmission hops (routers) that need to cross from the AMG1302/
AMG1202-TSeries to the destination.
Click this to save your changes.
Click this to restore your previously saved settings.
DESCRIPTION
Click this to configure a new IPv6 static route.
This is the number of an individual static route.
Chapter 9 Static Route
137