Using The Wps Button; Led Descriptions - ZyXEL Communications AMG1302-T series User Manual

Chapter 1 Introduction
Table 1 LED Descriptions
LED
(WPS/WLAN)
(DSL)
(INTERNET)

1.6 Using the WPS Button

You can also use the WPS button to quickly set up a secure wireless connection between the
AMG1302/AMG1202-TSeries and a WPS-compatible client by adding one device at a time.
To activate WPS:
Make sure the POWER LED is on and not blinking.
1
Press the WPS button for 1-5 seconds and release it. See below for WPS button location.
2
Press the WPS button on another WPS-enabled device within range of the AMG1302/AMG1202-
3
TSeries. The WPS LED should flash while the AMG1302/AMG1202-TSeries sets up a WPS
connection with the other wireless device.
Once the connection is successfully made, the WPS LED shines green.
4
18
COLOR STATUS DESCRIPTION
Green On The wireless network is activated.
Blinking The AMG1302/AMG1202-TSeries is communicating with other
wireless clients.
Green Blinking The AMG1302/AMG1202-TSeries is setting up a WPS connection.
Off The wireless network is not activated.
Green On The DSL line is up.
Blinking The AMG1302/AMG1202-TSeries is initializing the DSL line.
Off The DSL line is down.
Green On The AMG1302/AMG1202-TSeries has an IP connection but no
traffic.
Your device has a WAN IP address (either static or assigned by a
DHCP server), PPP negotiation was successfully completed (if
used) and the DSL connection is up.
Blinking The AMG1302/AMG1202-TSeries is sending or receiving IP traffic.
Red On The AMG1302/AMG1202-TSeries attempted to make an IP
connection but failed. Possible causes are no response from a
DHCP server, no PPPoE response, PPPoE authentication failed.
Off The AMG1302/AMG1202-TSeries does not have an IP connection.
WPS
AMG1302/AMG1202-TSeries User's Guide