ZyXEL Communications AMG1302-T series User Manual page 169

Table 58 Security > Filter > IP/MAC Filter (continued)
LABEL
Subnet Mask
Port Number
Protocol
IP / MAC Filter Listing
IP / MAC Filter Rule Index
#
Active
Interface
Direction
Src IP/Mask
Dest IP/Mask
Mac Address
Src Port
Dest Port
Protocol
Apply
Delete
Cancel
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
Enter the IP subnet mask for the destination IP address.
Enter the destination port of the packets that you wish to filter. The range of
this field is 0 to 65535. This field is ignored if it is 0.
Select ICMP, TCP or UDP for the upper layer protocol.
Select the index number of the filter set from the drop-down list box.
This is the index number of the rule in a filter set.
This field shows whether the rule is activated.
This is the interface that the filter set applies to.
The filter set applies to this traffic direction.
This is the source IP address and subnet mask when you select IP as the rule
type.
This is the destination IP address and subnet mask.
This is the MAC address of the packets being filtered.
This is the source port number.
This is the destination port number.
This is the upper layer protocol.
Click this to apply your changes.
Click this to remove the filter rule.
Click this to restore your previously saved settings.
Chapter 14 Filters
169