ZyXEL Communications AMG1302-T series User Manual page 180

Chapter 15 Firewall
Figure 84 Security > Firewall > Rules > Add
The following table describes the labels in this screen.
Table 63 Security > Firewall > Rules > Add
LABEL
Active
Action for Matched
Packets
IP Version Type
Rate Limit
Maximum Burst
Number
Log
Rules/Destination Address
180
DESCRIPTION
Select this option to enable this firewall rule.
Use the drop-down list box to select whether to discard (Drop), deny and send an
ICMP destination-unreachable message to the sender of (Reject) or allow the
passage of (Permit) packets that match this rule.
Select the IP version, IPv4 or IPv6, to apply this firewall rule to.
Set a maximum number of packets per second, minute, or hour to limit the
throughput of traffic that matches this rule.
Set the maximum number of packets that can be sent at the peak rate.
This field determines if a log for packets that match the rule is created or not.
AMG1302/AMG1202-TSeries User's Guide