ZyXEL Communications AMG1302-T series User Manual page 42

Chapter 4 Tutorials
AMG1202-TSeries as the AP and ZyXEL NWD210N as the wireless client which connects to the
notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the AMG1302/
AMG1202-TSeries. A wireless client must also use the same PIN in order to download the wireless
network settings from the AMG1302/AMG1202-TSeries.
Push Button Configuration (PBC)
Make sure that your AMG1302/AMG1202-TSeries is turned on and your notebook is within the cover
1
range of the wireless signal.
Make sure that you have installed the wireless client driver and utility in your notebook.
2
Make sure wireless LAN is enabled and the wireless security mode is set to WPA-PSK2 or No
3
Security in the Network Setting > Wireless > General screen.
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button
4
(Start or WPS button).
Push and hold the WPS button on the AMG1302/AMG1202-TSeries for 1-2 seconds. Alternatively,
5
you may log into AMG1302/AMG1202-TSeries's web configuration, enable WPS and click the WPS
button in the Network Setting > Wireless > WPS screen.
Note: It doesn't matter which button (on the client or the AMG1302/AMG1202-TSeries) is
pressed first. You must press the second button within two minutes of pressing the
first one.
The AMG1302/AMG1202-TSeries sends the proper configuration settings to the wireless client. This
may take up to two minutes. The wireless client is then able to communicate with the AMG1302/
AMG1202-TSeries securely.
42
AMG1302/AMG1202-TSeries User's Guide