ZyXEL Communications AMG1302-T series User Manual page 35

• If the Internet connection fails, check to see if your account is activated.
After you configure the Internet access information, use the following screen to set up
your wireless LAN.
Check the Wireless Service box to enable wireless connection on the ZyXEL device.
5
Configure your wireless settings in this screen. Click Next.
6
Figure 13 Wireless Setup
The following table describes the labels in this screen.
Table 7 Wireless Setup
LABEL
Wireless
Service
Wireless
Network
Name(SSID)
Channel
Selection
Security
Pre-Shared
Key
Back
Next
Exit
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
Click this to enable or disable wireless service on the ZyXEL device.
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the
wireless LAN.
If you change this field on the AMG1302/AMG1202-TSeries, make sure all
wireless stations use the same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is
called a channel. Select a channel ID that is not already in use by a
neighboring device.
Displays the security setting. To mofidy, see
Enter a set of characters (8 to 63 characters or 64 hexadecimal digits [a-f,
A-F, and 0-9]) for the shared security key.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
Chapter 3 Internet / Wireless Setup Wizard
Section 7.2 on page 92.
35