ZyXEL Communications AMG1302-T series User Manual page 31

The following table describes the fields in this screen.
Table 3 Internet Access Wizard Setup: IPoA Configuration
LABEL
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation
Multiplex
VPI
VCI
IP Address
Default
Gateway
Primary DNS
Server
Secondary
DNS Server
Back
Next
Exit
Note: Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI) define a virtual circuit.
Figure 10 Internet Connection with ENET ENCAP
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
drop-down list box: IPoA, ENET ENCAP, PPPoA, or PPPoE.
Select the multiplexing method used by your ISP from the Multiplex
drop-down list box either VC-based or LLC-based.
Enter the Virtual Path Identifier (VPI) assigned to you. This field may
already be configured.
Enter the Virtual Channel Identifier (VCI) assigned to you. This field may
already be configured.
Enter the IP address of the AMG1302/AMG1202-TSeries.
Enter the default gateway of the ZyXEL Device.
Enter the primary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Enter the secondary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen. The next wizard screen
you see depends on what protocol you chose above.
Click this to close the wizard screen without saving.
Chapter 3 Internet / Wireless Setup Wizard
31