Insertion; Inserting/Removing The Cover; Inserting The Cover; Removing The Cover - Becker CASCADE PRO Operation Manual

General operation

Insertion

! Take the control panel out of its pro-
tective cover.
Insert the left-hand side of the control
!
panel.
! Push the control panel into place.
The Cascade is now ready for operation
and can be switched on, or it will switch
itself on automatically.
16

Inserting/Removing the cover

The scope of supply of the Cascade
includes a red plastic insert. This plastic
insert can be snapped into the gap which
appears once the control panel has been
removed.
As well as serving as a protective cover
for any CF card/micro-drive, the red col-
our of the plastic insert clearly indicates
that the control panel has been removed.

Inserting the cover

! Remove the control panel as described
in "Removing/Inserting the control
panel" on page 15.
Insert the plastic insert into the gap
!
with the hole at the top and the smooth
side facing outwards.
! Push the lower section of the plastic
insert into the gap until it snaps into
place.
The cover has now been inserted.
Reinsert the control panel as described
!
in "Removing/Inserting the control
panel" on page 15.

Removing the cover

! Remove the control panel as described
in "Removing/Inserting the control
panel" on page 15.
Insert your finger into the hole in the
!
plastic insert.
! Carefully push the plastic insert down-
wards.
! Pull the plastic insert forwards.
The cover has now been removed.
Reinsert the control panel as described
!
in "Removing/Inserting the control
panel" on page 15.