Inserting Memory Card - Becker CASCADE PRO Operation Manual

cal situation, due to permanent changes to
road systems and their traffic regulations.
Note:
For Norway, Sweden, Finland, Den-
mark, Spain and Italy, non-verified data
has been used to achieve a high depth of
digitisation; i.e. with this data, the nav-
igation system cannot refer to informa-
tion such as motorway, trunk road, 30
zone, one-way street or other traffic
regulations, as this is not recorded.
All roads can be used, but optimum
route guidance cannot be guaranteed.

Inserting memory card

The slot for memory cards containing
navigation data is located underneath the
removable control panel on the Cascade
or underneath the cover.
Remove the control panel as described
!
in "Removing/Inserting the control
panel" on page 15.
! Remove the cover as described in "In-
serting/Removing the
page 16.
! Take the memory card containing the
navigation data out of its protective
sleeve.
Insert the memory card into the visible
!
slot on the right-hand side.
Notes:
The memory card can only be inserted
in one direction. The reverse of the
memory card points to the left.
! Push the memory card carefully into
the slot.
This pushes the eject button located
above and to the left of the slot out-
wards.
! Reinsert the cover as described in "In-
serting/Removing
page 16.
Reinsert the control panel as described
!
cover" on
in "Removing/Inserting the control
panel" on page 15.
The memory card containing the naviga-
tion data is now ready for operation and
the system is able to access the naviga-
tion data.
Navigation mode
the cover" on
25