Operating Mode; Dig/Analog; Name; Tone Mode - Yaesu ADMS-12 Instruction Manual

• Operating Mode

Select the operating mode for receive channel.
FM: The selected frequency band is set to FM mode.
AM: The selected frequency band is set to AM mode.

• DIG/ANALOG

The AMS, V/D mode (DN), the Voice FR mode (VW) and the ANALOG mode (FM/AM mode) are select-
able.
When the Setup Menu [TX/RX]  [2 DIGITAL]  [5 DIGITAL VW] is set to "ON", the Voice FR mode
(VW) can be selected.

• Name

Enter the desired memory name (up to 16 digits).

• Tone Mode

This item selects the Audio Squelch Code type.

• CTCSS Frequency

This item selects the Tone Frequency of the Tone Squelch.

• DCS Code

Select the DCS code when DCS is set.

• User CTCSS

Select the idle line frequency to remove signals such as idle line signals used by private railways and con-
trol signals of MCA radio system.

• RX DG-ID

Select the receiving DG-ID number.

• TX DG-ID

Select the transmitting DG-ID number

• Tx Power

This item selects the TX Power.

• Step

Sets the channel step for receiving channels.

• Narrow

By ticking the checkbox of this item, switches to the Narrow FM mode.

• Clock Shift

When an internal spurious signal occurs due to the microcomputer clock, turn this setting on (tick the
checkbox). This may improve the situation.
Usually, this item is set to "OFF" (un-tick the checkbox).

• Comment

Comments may be added to the registered memory channels. Up to 255 letters can be used. This function
is useful in organizing the memory channels by, for example, applying a category name to each channel.
These comments are not transferred to the FTM-300DR/DE.
23