Adjusting Top-Of-Form Origin; Adjust Options And Values - Genicom LA36 User Manual

Adjusting Top-of-Form Origin

Print positions often change gradually when you use the printer over long periods of time.
The ADJUST function allows you to adjust these positions by fine-tuning the Top-of-Form
origin.
The following table describes the ADJUST options and values. Options are listed in the
order they are printed.

ADJUST Options and Values

• Overprinted values are the factory settings.
A D J U S T
Options
<FNFOLD ADJ>
(Fanfold
Adjustment)
<MNUAL ADJ>
(Manual
Adjustment)
<RESVD 1>
<RESVD 2>
Values
###/60 IN
###/60 IN
Using Set-Up Mode
Description
Adjust the Top-of-Form origin for
continuous forms in increments of 1/60
inch (0.42 mm) from the physical top of
the page.
-10 to 10 (0)
Number of 1/60 inches
Adjust the Top-of-Form origin for
single sheets in increments of 1/60 inch
(0.42 mm) from the physical top of the
page.
-10 to 10 (0)
Number of 1/60 inches
Reserved
Reserved
4-29