Positioning the Paper Stack
Place the stack of continuous forms paper directly below the rear of the printer 1 1 1 1 1 for push,
rear feed or below the bottom slot of the printer 2 for pull, bottom feed.
When using paper-stapled multipart forms in push feed, raise the cut sheet stand 3.
Caution:
After the paper is installed in the printer, the paper path should look like this:
Good placement
Push-feed, from rear slot
Pull-feed, from bottom slot
Bad placement
1
2
Placement of Continuous Forms
Push-feed, from rear slot
with paper-stapled multipart forms
Paper Handling
3
2-15