Buffer; Interface Type; Auto Switch; Baud Rate - Genicom LA36 User Manual

I N S T A L L
Options Values
<BUFFER>
2
8
16 KBYTE
32 KBYTE
64 KBYTE
Select the type of interface to the computer.
<I/F TYPE>

(Interface Type)

PARALLEL
SERIAL
AUTO
Specify the timing of regarding the selected protocol or interface as
<AUTO SW>

(Auto Switch)

2
4
6
8
10 SEC
12 SEC
14 SEC
16 SEC
18 SEC
20 SEC
I N S T A L L
Options Values
<BAUD RATE>
Description
Assign buffer memory as the input buffer.
2K bytes
KBYTE
8K bytes
KBYTE
16K bytes
32K bytes
64K bytes
Note:
The larger the input buffer selected, the smaller
the download buffer becomes. Even with 64K bytes
of input buffer, a minimal download buffer is
provided. If you need a larger capacity for
downloading fonts, reduce the input buffer.
Centronics parallel interface
DEC-423 serial interface
Both interfaces are ready for communication. The
printer communicates with the interface from which it
first receives data. The interface is active until the
input buffer becomes empty.
being inactive when AUTO is specified in the
<PROTOCOL> or <I/F TYPE> option.
2 seconds elapsed after data stops from the computer
SEC
4 seconds elapsed after data stops from the computer
SEC
6 seconds elapsed after data stops from the computer
SEC
8 seconds elapsed after data stops from the computer
SEC
10 seconds elapsed after data stops from the computer
12 seconds elapsed after data stops from the computer
14 seconds elapsed after data stops from the computer
16 seconds elapsed after data stops from the computer
18 seconds elapsed after data stops from the computer
20 seconds elapsed after data stops from the computer
Description
Setting of data transmission speed for DEC-423. The
baud rate is in bps (bits per second). Select the same
Using Set-Up Mode
4-27