Switching Paper Types - Genicom LA36 User Manual

– To increase the Top-of-Form value of a 1/60 inch, press the
The paper moves forward.
– To decrease the Top-of-Form value of a 1/60 inch, press the
The paper moves backward.
– To reset the Top-of-Form value to 0, press the
The paper moves to the edge of the page (position 0).
Note: If you reach the limit of the permitted range, the printer beeps, and the paper
stops moving.
4. Save the Top-of-Form value:
– To permanently save the value, press the
The printer returns to Normal mode.
– To temporarily save the value, press the
The printer returns to Normal mode. (The new value is lost at the next power-off.)
Note: The use of the
software errors (

Switching Paper Types

If you have more than one type of job, it is often necessary to switch between continuous
forms and single sheets. This section explains how to switch between paper types. It is not
necessary to remove the continuous forms paper from the printer.
Caution: This function is not available for continuous forms paper that is fed by the pull-
tractor.
Exit/Save
Set-Up/Quit
and buttons for micro-feeding is available for some cases of
indicator blinking).
Fault
button.
button.
Top button.
button.
button.
Paper Handling
2-29