Ejecting Single Sheets - Genicom LA36 User Manual

6. If you want to slightly adjust the Top-of-Form position, the first line on which printing
can start, adjust the Top-of-Form position of the paper using control panel buttons. Press
the Set-Up/Quit and the
alternately with the
mode. Press the
in 1/60-inch increments. Press the
that this adjustment is temporarily saved. It will not be active at next power-up of the
printer. For permanent adjustment, see the section "Feeding and Positioning Paper" later
in this chapter.
7. Place the printer in the Ready state. Print a sample page and check the page margins.
Make the following adjustments, as necessary:
• Horizontal alignment. Readjust the paper guides if required.
• Top-of-form setting. Use the printer Set-Up mode (see Chapter 4, "Using Set-Up
Mode,") or the TOF Adjustment mode (see the section, "Feeding and Positioning
Paper," later in this chapter).
• Margin settings. Use your software or the printer Set-Up mode (see Chapter 4,
"Using Set-Up Mode.")

Ejecting Single Sheets

If you print using software, each sheet is ejected automatically upon the completion of the
page printing. To manually eject sheets of paper:
• Press the FF/Load
• Turn the platen knob.
Loading a Sheet of Paper
Top buttons at the same time. The
DEC and PPX24 indicators, indicating Top-of-Form Adjustment
button or the button. The paper will move forward or backward
Set-Up/Quit
button to execute a forward form feed.
3 3 3 3 3
M1 and M2 indicators flash
button after adjusting the position. Note
Paper Handling
2-13