Installing/Removing The Server Into The Rack - Fujitsu PRIMERGY RX600 S3 Operating Manual

Hardware Installation
4.3 Installing/Removing the Server into the
Rack
V
CAUTION!
Please observe the safety precautions and references to rack instal-
lation in
At least two people are needed to position the server in the rack.
The rack may tip over if more than one unit is removed at the same
time from the rack.
Requirements of the Rack
The rack systems of Fujitsu Siemens Computers (PRIMECENTER Rack,
DataCenter Rack) perfectly support the installation of the PRIMERGY server
systems. Installation into current OEM rack systems (3rd-Party Racks) is
possible, if they support the EIA-310-D standard for 19-inch racks.
I
Classic Rack is not supported with the PRIMERGY RX600 S3.
To accommodate the ventilation concept and ensure proper ventilation of the
components in the rack, any unused areas must be closed using dummy covers.
Power is supplied via the socket strips available in the rack.
The main features of the rack systems of Fujitsu Siemens Computers are as
follows:
PRIMECENTER Rack
– In connection with so-called assembly brackets frontally bolted telescopic
rails or sliding rails.
Two of these assembly brackets and/or the sliding rails are provided with a
linear alignment possibility to ensure an adjustment to different rack depths.
– Extended cable management within the lateral rack area.
U41662-J-Z156-1-76

Installing/Removing the Server into the Rack

chapter "Important Notes" on page 19.
33