Installing/Removing The Server Into The Rack; Requirements Of The Rack - Fujitsu PRIMERGY RX100 Operating Manual

Hardware Installation
4.3 Installing/Removing the Server into the
Rack
V
CAUTION!
Please observe the safety precautions and references to rack instal-
lation in chapter "Important Notes" on page 11.
The rack may tip over if more than one unit is removed at the same
time from the rack.
V
CAUTION!
No cable management is available for the server!
Before removing the server from the rack, all cables connected on the
server must be unpluged from the sockets. Proceed as follows:
Ê Close all applications and shut down the operating system in a
orderly manner.
Ê Switch OFF the server.
Ê Disconnect all cables from the server.
Ê Remove the server.
4.3.1

Requirements of the Rack

The rack systems of the Fujitsu Siemens Computers GmbH (PRIMECENTER
Rack; DataCenter Rack and 19-Inch (Classic) Rack) support fully the instal-
lation of the PRIMERGY server systems. The installation into the present rack
systems from different manufacturers (3rd-Party Rack) can also be supported.
To accommodate the ventilation concept and ensure proper ventilation of the
components in the rack, any unused areas must be closed using dummy covers.
The power is supplied via the socket strips available in the rack.
A26361-K875-Z102-3-7619

Installing/Removing the Server into the Rack

23