Switching The Server On And Off - Fujitsu PRIMERGY RX600 S3 Operating Manual

Commissioning and Operation
5.2

Switching the Server ON and OFF

V
CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see
Solutions and Tips" on page
The ON/OFF button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plugs.
Switching the Server ON
The power-on indicator on the front does not light (position 7 on
page 49). The power indicator on the power supply units lights when the server
is connected to the mains (position 3 in
– First system installation:
Ê Press the ON/OFF button (position 10 in
The power-on indicator lights green.
Ê Insert the ServerStart-CD into the CD/DVD drive.
Ê Follow the instructions on the monitor (see also
with ServerStart" on page 64
Start" on page
– System already installed:
Ê Press the ON/OFF button (position 10 in
The server is switched ON, performs a system test and boots the
operating system.
Switching the Server OFF (ACPI-compatible Operating Systems, e.g.
Windows 2000, Linux)
Power-on indicator lights green (position 7 on
Ê Shut down the operating system in an orderly manner.
The server is switched OFF automatically and goes to standby mode.
The power-on indicator is dark.
U41662-J-Z156-1-76
71).
or section "Configuration without Server-
65).
Switching the Server ON and OFF
figure 20 on page
figure 14 on page
section "Configuration
figure 14 on page
figure 14 on page
chapter "Problem
figure 14 on
60).
49).
49).
49).
61