Fujitsu PRIMERGY RX600 S3 Operating Manual page 20

Notes on Safety
Before Setting up
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device (see
"Technical Data" on page
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the installation site.
Failure to observe these guidelines can lead to material damage of
the device.
Transport the device only in the original packaging or in a packaging
which protects it from knocks and jolts.
Installation and Operation
V
CAUTION!
If the rack model is integrated in an installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
The server automatically sets itself to a voltage in the range of
200 V - 240 V. Make sure that your local voltage is within this range.
This device has safety tested power cables and must only be
connected to properly grounded power sockets.
Ensure that the power sockets on the device or the grounded mains
outlet are freely accessible.
The power switch does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, the
power plugs must be removed from the grounded power sockets.
20
14).
Important Notes
section
U41662-J-Z156-1-76