Connecting The Server To The Mains Voltage - Fujitsu PRIMERGY RX600 S3 Operating Manual

Hardware Installation
There are more ports on the rear, see
Figure 12: Rear ports (right)
1 LAN port
(currently not usable, reserved for
future extensions)
Ê Connect the data cables to the server and peripherals.
I
Keyboard and mouse are to be connected via USB. There are no PS/2
ports available for these devices.
4.5

Connecting the Server to the Mains Voltage

The server has two hot-plug power supply units. This ensures a redundant
power supply. If a defect occurs in one power supply unit, the respective other
power supply unit ensures unimpaired further operation. Each hot-plug power
supply may be replaced while the system is operating (see
plug Power Supply Unit" on page
V
CAUTION!
The server automatically sets itself to a voltage in the range of
200 V - 240 V. Make sure that your local voltage is within this range.
U41662-J-Z156-1-76
Connecting the Server to the Mains Voltage
figure 12.
2 SCSI port (optional, connected to
SCSI channel B or to an
additional PCI board)
75).
2
1
"Replacing a Hot-
45