Fujitsu PRIMERGY RX600 S3 Operating Manual page 93

Hot-plug Components
Removing the Snap-fits
Figure 35: Removing the snap-fits from the pull-out aid
Ê Slide the green snap-fits downwards until they are released from the pull-out
aid (1).
Ê Take the snap-fits (1) and keep them.
Ê For inserting a new PCI board please continue with section
plug PCI Board" on page
V
CAUTION!
If a PCI board is removed and not replaced with a new board, a dummy
module must be reinstalled due to cooling, to comply with applicable
EMC regulations (regulations on electromagnetic compatibility) and to
protect against fire. Make sure that the dummy module engages correctly
it its location.
U41662-J-Z156-1-76
96.
PCI boards
"Inserting a Hot-
93