Mounting Into The Primecenter Rack - Fujitsu PRIMERGY RX600 S3 Operating Manual

Hardware Installation
4.3.1

Mounting into the PRIMECENTER Rack

For mounting the server in the PRIMECENTER Rack the following parts are
necessary:
– one support bracket with two M5x10 screws including plugwashers
– one rack mounting kit consisting of two telescopic rails (left/right), ready for
use
– eight centering screws M5 (two each for front and rear, left and right)
I
General information is provided in the Technical Manual for the PRIME-
CENTER Rack (see also
For mounting the left telescopic rail in the PRIMECENTER Rack, the delivered
support bracket must first be mounted on the rear left support upright.
Figure 5: Mounting the support bracket
Ê Mount the support bracket at the appropriate height on the left rear support
upright as described in the Technical Manual of the PRIMECENTER Rack.
I
For better orientation, the height units are marked on the support
uprights.
U41662-J-Z156-1-76
Installing/Removing the Server into the Rack
"Related publications" on page 107).
37