U41662-J-Z156 - Fujitsu PRIMERGY RX600 S3 Operating Manual

Power supply units
1
Figure 21: Releasing and pulling out a power supply unit
Ê Remove the cable from the defective power supply unit.
Ê Release the thumbscrew (1) and rotate the handle in the direction of the
arrow (2).
Ê Pull the defective power supply unit completely out of the bay (3), using the
handle.
V
CAUTION!
Never leave the power supply bay empty for longer than two minutes
during operation. Otherwise, system components might be damaged
because of excessive temperatures.
Ê With the handle in the open position, insert the new power supply unit into
the free bay until it engages.
Ê Rotate the handle to the close position and tighten the thumbscrew (1).
I
Please ensure that the new power supply unit engages correctly in
the bay and is locked in position.
This is the only way to avoid the power supply unit being shaken out
of its mountings and damaged during transport.
Ê Connect the new power supply unit to the mains.
If the unit is operating normaly, the green LEDs 1 and 3 on the power supply
unit should be lighting (see
on page 60).
76
2
"Indicators on the Hot-plug Power Supply Units"
Hot-plug Components
3

U41662-J-Z156-1-76