Unpacking The Server; Installing/Removing The Server Into/From The Rack - Fujitsu PRIMERGY RX300 S3 Operating Manual

Unpacking the Server

4.1 Unpacking the Server
V
CAUTION!
Please note the safety instructions in
page 23.
If you need to lift or transport the server, ask other people to help
you.
Do not unpack the server until it is at its installation location.
Ê Transport the server to the place where you want to set it up.
It is recommended not to throw away the original packaging material as it may
be required for transportation at a later date.
Ê Unpack all individual parts.
Ê Check the delivery for any damage during transport.
Ê Check whether the delivery agrees with the details on the delivery receipt.
The identification rating plate is located on the rear area on the server.
Notify your supplier immediately should you discover that the delivery does not
correspond to the delivery receipt.
4.2 Installing/Removing the Server into/from
the Rack
V
CAUTION!
Please observe the safety notes in
page 23
page 30.
At least two people are needed to position the server into/out of
the rack.
The rack can tip over when more than one unit is pulled out.
The server may not occupy the top height unit of the rack (38 HU/42
HU PRIMECENTER Rack and/or DataCenter Rack), as otherwise no
board and/or fan can be replaced even with the unit pulled out
completely.
34
and in the section "Notes on Installing into the Rack" on
Operating manual
Hardware Installation
chapter "Important Notes" on
chapter "Important Notes" on
RX300 S3