Installing/Removing the Server into the Rack
1
Figure 9: Fastening the server
Ê Place the cage nuts for fastening the front panel in the corresponding holes
of the front support uprights and fasten the server using two knurled screws
(1).
Ê The HDD modules are each provided with a transport lock. Remove the
locks before you commission the server (see
transport lock" on page
To remove the server, follow the same procedure in the reverse order. When
removing the server make sure you pull out the left and right chassis holders
(see
figure 7 on page
42
81).
40) in parallel.
Hardware Installation
"HDD module: removing the
U41662-J-Z156-1-76
1