Installing/Removing The Server Into/From The Rack - Fujitsu PRIMERGY RX100 S3 Operating Manual

Hardware Installation
4.3 Installing/Removing the Server into/from
the Rack
V
CAUTION!
Please note the safety instructions in
page 15
The rack can tip over when more than one slide-in unit is pulled out.
V
CAUTION!
There is no cable management for the server in the rack!
Before the server is removed, all cables must be disconnected from the
sockets. Please proceed as follows:
– Terminate all applications and shut down the operating system.
– Switch off the server.
– Disconnect and remove all cables connected to the server.
– Remove the server from the rack.
U41615-J-Z156-1-76

Installing/Removing the Server into/from the Rack

and in section "Notes on Installing the Rack" on page
chapter "Important Notes" on
22.
27