Fujitsu PRIMERGY RX600 S3 Operating Manual page 95

Hot-plug Components
Removing the Supporting Plate from the Pull-out Aid
Figure 36: Removing the supporting plate from the pull-out aid
V
CAUTION!
When removing the PCI board from the pull-out aid, pay special attention
to the snap-fits holding it attached to the pull-out aid (see
page 92). Do not lift them more than approx. 1 mm, i. e. only wide enough
to have the PCI board released. Otherwise the snap-fits could be
damaged.
Ê Lift the green movable snap-fits, but not more than approx. 1 mm (1) until the
PCI board is released completely.
Ê Take the supporting plate off (2), and put it aside.
I
Keep the supporting plate for future use.
Ê Slide the green snap-fits downwards until they are released from the pull-out
aid (see figure 35 on page
U41662-J-Z156-1-76
93) and keep them.
PCI boards
figure 34 on
95