Installing/Removing The Server Into/From The Rack - Fujitsu PRIMERGY RX220 Operating Manual

Hardware Installation
4.3 Installing/Removing the Server into/from
the Rack
V
CAUTION!
Please note the safety instructions in
page 17
The rack can tip over when more than one slide-in module is pulled
out.
V
CAUTION!
No cable management is available for the server!
Before removing the server from the rack, all cables connected on the
server must be unpluged from the sockets. Proceed as follows:
Ê Close all applications and shut down the operating system in a
orderly manner.
Ê Switch OFF the server.
Ê Unplug all cables from the server.
Ê Remove the server.
RX220

Installing/Removing the Server into/from the Rack

and in section "Notes on Installing into the Rack" on page
Operating Manual
chapter "Important Notes" on
24.
29