Obihai OBi100 Administration Manual page 77

Low
DSCP to Priority Class
Mapping
N
(N = 0 – 63)
OBiWiFi Wireless USB Adapter
Note: OBiWiFi is available on the OBi2 Series and OBi3 Series models only.
OBiWiFi supports the 8021.11 b/g/n wireless standards so that an OBiWiFi Wireless Adapter may be used with the USB 2.0
port of the OBi2 Series and OBi3 Series devices. From an IP routing point of view, OBiWiFi is an additional WAN interface. If
both WAN interfaces are connected (Ethernet port and OBiWiFi), the traffic destined to the WAN side will route through
the Ethernet interface only, unless a) the WAN (Ethernet) interface and OBiWiFi are on different subnet and b) the
destination address is on the same subnet as OBiWiFi.
If the OBi is set to function as a LAN switch rather than a router, OBiWiFi is disabled internally.
The guaranteed uplink bandwidth allocation weight for Low
Priority class traffic. It must be a value between 1 and 10
The priority class to be assigned to the packet which has the DSCP
code equal to N in the IP header. The choices are:
Restricted
High
Medium
Low
Note: Restricted class has the highest priority
Copyright 2010-2013 Obihai Technology, Inc.
2
For N = 8, 10, 12, or 14,
the default is Low.
For N = 48 or 56, the
default is High.
For all other DSCP codes,
the default is Medium
77