Obihai OBi100 Administration Manual page 116

CallForwardUnconditionalNumber
CallForwardOnBusyEnable
CallForwardOnBusyNumber
CallForwardOnNoAnswerEnable
CallForwardOnNoAnswerNumber
CallForwardOnNoAnswerRingCount
X_BlockedCallers
MWIEnable
MWIEnable2
phone using a Star Code
Directory number to forward all incoming calls on this service
unconditionally. Maximum Length is 127 characters.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable call forwarding of all incoming calls when the device is
busy. If CallForwardOnBusyNumber is blank, this parameter is
treated as if it has been set to No. Device is considered busy if
one of the following conditions holds:
This service already reaches the limit of simultaneous calls as
specified in MaxSessions
DND (Do Not Disturb) Service is enabled on this service
If the call is routed to the PHONE port where the phone is in a
busy state (such as ringing, dialing, playing reorder, or already
having 2 calls in progress)
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Directory number to forward all incoming calls on this service
when the device is busy. Maximum Length is 127 characters.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Enable call forwarding of all incoming calls when the call is not
answered after a period as specified in
CallForwardOnNoAnswerRingCount. If
CallForwardOnNoAnswerNumber is blank, this paramete is
treated as if it has been set to No.
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Directory number to forward all incoming calls when the call is
not answered after a period specified in
CallForwardNoAnswerRingCount
Note: It is possible for a user to set this parameter from the
phone using a Star Code
Number of rings to be considered by the device as no answer to
an incoming call.
Note: 1 ring is approximately 6s
A comma separated list of up to 10 caller numbers to block from
calling this service.
Note: Option not available on OBi100 and 110
Enable Message Waiting Indication Service for this service. If
enabled, device plays stutter dial tone on the PHONE port (or
PHONE1 port) when there are new messages for the subscriber.
It will also turn on VMWI signal on the PHONE port (or PHONE1
ort) if X_VMWIEnable is set to Yes
Enable Message Waiting Indication Service for this service. If
enabled, device plays stutter dial tone on the PHONE2 port when
there are new messages for the subscriber. It will also turn on
Copyright 2010-2013 Obihai Technology, Inc.
No
No
2
No
No
116