Obihai OBi100 Administration Manual page 192

- PH1 = the PHONE Port (same as PHONE1 port)
- PH2 = the PHONE2 Port
- AA1 = the Auto Attendant
Unless stated otherwise, abbreviated endpoint names are case insensitive. A trunk or an endpoint is also referred to as a
Terminal in this document.
The following matrix shows the possible call connections between the endpoints and the trunks:
Supported endpoint calls on the OBi
Any Trunk
Any Trunk n/a
PHONE Port
yes
(PHONE1 Port)
PHONE2 Port yes
AA yes
Call Routing – The OBi Way
Call Routing is the process by which the OBi Device sets up a call bridge or a (endpoint) call based on such information as:
the trunk on which the call originates, the caller's number, the called number, etc. Call Routing Rules are parameters used
to instruct the OBI device how to route calls. A call may transform into a call bridge or an endpoint call after being routed by
the OBi according to the given routing rules.
Every call has to be originated from somewhere. From the device's perspective, calls originated from the trunk side are
considered Inbound Calls, while calls originated from an endpoint Outbound Calls. The call routing rule syntaxes for
inbound calls and outbound calls are slightly different and we shall explain them separately below. Call Routing Rule
configuration relies heaving on digit maps. If you are not familiar with how digit map works yet, please read the Digit Map
Configuration Section in this document first.
5
PHONE2 or PH2 Port is available on the OBi202/OBi302 only
5
PHONE Port PHONE2 Port
(PHONE1 Port)
yes
no
yes
yes
Copyright 2010-2013 Obihai Technology, Inc.
5
AA
yes Yes
yes Yes
no Yes
yes No
192