Obihai OBi100 Administration Manual page 195

3) {(x.4081113333|x.4152224444):aa},{ph}
It says: Ring the AA for calls coming from any number that ends with 408 111 3333 or 415 222 4444, and ring the PHONE
port for all other calls. Be sure to include the enclosing parentheses in this example since "x." is a digit map specific syntax.
4) {200123456:aa},{sp1(14083335678)}
It says: Ring the AA for calls coming from 200123456. For all any other call, bridge it by calling 1 408 333 5678 using SP1
Service
Outbound Call Route Configuration
Every endpoint has an OutboundCallRoute parameter in the OBi device configuration. It tells the device where to send the
call when the endpoint attempts to make a call. Endpoints may call each other or an outside number using one of the
trunks. The OutboundCallRoute syntaxes are almost identical to those of the InboundCallRoute; the differences are mainly
in the implied value when an optional field is omitted, no caller objects and one and only one terminal object per terminal-
list in an OutboundCallRoute. Forking is not supported when routing outbound calls.
The general format is:
OutboundCallRoute := rule OR {rule},{rule},....
Note that the curly braces may be omitted if there is only one rule in the route. The OR operator is NOT part of the
parameter syntax; it is used here to separate alternative values only.
A rule has the following format:
rule := callee-list : terminal
where
callee-list := callee|callee|callee| ...
callee := number OR embedded-digit-map OR @
terminal := PHx OR AAx OR LIx(arg) OR SPx(arg) OR PPx(arg)
arg := cid > target
x := 1 OR 2 OR 3...
cid = spoofed-caller-number
target = number-to-call OR $2
embedded-digit-map = (Mlabel) OR digit-map
(vertical bar separated list of 0 or more callee object)
(@ = any number)
Copyright 2010-2013 Obihai Technology, Inc.
(arg object is optional)
(where applicable; can be omitted if it is equal to 1)
195