Obihai OBi100 Administration Manual page 178

- Same as kat except applies the result on SP1 Service only
*67, Block Caller ID Once, set($BCI1,1)
- Enable masking of caller ID information once for the next call on any trunk
*99, Disable Echo Canceller For One Call, set($Noec1,1)
- Disable the Echo Canceller for one call on the current phone port
*74(x|xx), Set Speed Dial, coll($Spd[$code])
- After user dials *74, OBi expects one or two more digits from the user which represent a speed dial slot index (1 to
99). The 1 or 2-digit variable part is stored in the variable $code.
- OBi device then plays a prompt tone and proceeds to collect a number from the user according to the DigitMap.
Finally OBi stores the collected number in the given speed dial slot. If the slot already has a number specified, it
will be overwritten quietly with the new value.
*75(x|xx), Check Speed Dial, say($Spd[$code])
- After user dials *75, OBi expects one or two more digits from the user which represent a speed dial slot index (1 to
99). The 1 or 2-digit variable part is stored in the variable $code.
- OBi device then announces the number stores in the speed dial slot, or says "not available" if the slot is empty.
Copyright 2010-2013 Obihai Technology, Inc. 178