Obihai OBi100 Administration Manual page 112

X_UserAgentPort
DirectoryNumber
X_DefaultRing
X_CallOnHoldRing
X_RepeatDialRing
X_BargeInRing
X_CallParkedRing
X_SIPDebugOption
X_SipDebugExclusion
X_SatelliteMode
X_Proxy
SIP messages for keep-alive are sent only once without
retransmission; response to the SIP messages are ignored by the
OBi.
Note: Option not available on OBi100 and OBi110
UDP port where the device sends and listens for SIP messages
Directory number associated with this service
Default ring pattern number to ring the PHONE port for incoming
calls on this trunk that are routed to the PHONE port according
to the InboundCallRoute of this service. The ring pattern is taken
from the selected Ring Profile. Valid choices are 1-10
Pattern to ring PHONE port when holding a call on this trunk that
has been connected to the PHONE port. Typically this is a very
short distinctive ring pattern that serves as a reminder to the
user that a call is being on hold. The ring pattern is taken from
the selected Ring Profile. Valid choices are: NO Ring, or 1-10
The ring pattern number to use to ring the PHONE port when a
repeat dial operation on this trunk is successful as the called
party is either ringing or answered
Call Waiting Ring pattern to ring the PHONE port when the
incoming call is requesting to barge-in. This is applicable in a call-
waiting scenario on the PHONE port
Ring pattern to ring the PHONE port only as a reminder that
there are some calls parked in the parking lot. This feature is
applicable only in an OBiPLUS solution.
Enable sending of SIP signaling debug information to the syslog
server (if one is configured on the device). Available choices are:
Disable (do not send SIP signaling debug information)
Log All Messages
Log All Except REGISTER Messages
A list of SIP methods to exclude from the syslog for this SP
service. For example: notify, subscribe
Enable satellite mode on this trunk. In this mode, the user must
explicitly sign on (using * code) to receive phone calls on this
trunk. The SIP REGISTER sent by the OBi to the ITSP on this trunk
will indicate if the user wants to sign on (and therefore takes
over the incoming calls for this account). This feature is only
applicable if the service is provided by an OBiPLUS system
Note: Option not available on OBi100/OBi110
Enable proxy mode operation on this SP service. If enabled, the
SP will accept SIP Registration from one client device from the
LAN side, which must be using the same user-id and password as
this SP's AuthUserName and AuthPassword parameters, for
authentication. The client device, known as the local_client, may
send SIP INVITE to the OBi at this SP to make calls; this SP's
InboundCallRoute must be set up with the proper routing rule to
handle calls from the local_client.
The SIP Proxy Server parameter on the local_client should be set
to:
<obi-number>.pnn.obihai.com:<sp-user-agent-port>
Copyright 2010-2013 Obihai Technology, Inc.
5060
1
8
5
4
10
Disable
No
No
112