HP 4800G Series Configuration Manual page 1810

Information channel
number
4
5
6
7
8
Configurations for the six output destinations function independently and take effect only after the
information center is enabled.
Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and configuration modules.
The system information can be classified, filtered, and output according to source modules. You can
use the info-center source ? command to view the supported information source modules.
Default output rules of system information
The default output rules define the source modules allowed to output information on each output
destination, the output information type, and the output information level as shown in
indicates that by default and in terms of all modules:
Log information with severity level equal to or higher than informational is allowed to be output to
the log host; log information with severity level equal to or higher than warning is allowed to be
output to the console, monitor terminal, and log buffer; log information is not allowed to be output to
the trap buffer and the SNMP module.
All trap information is allowed to be output to the console, monitor terminal and log host; trap
information with severity level equal to or higher than warning is allowed to be output to the trap
buffer and SNMP module; trap information is not allowed to be output to the log buffer.
All debugging information is allowed to be output to the console and monitor terminal; debugging
information is not allowed to be output to the log host, log buffer, trap buffer and the SNMP module.
Table 1-3 Default output rules for different output destinations
Output
Modules
destinati
allowed
on
default
Console (all
modules)
Default channel name
logbuffer
snmpagent
channel6
channel7
channel8
LOG
Enabled/
Severity
disabled
Enabled Warning
1-3
Default output destination
Log buffer (Receives log and debugging
information, a buffer inside the router for
recording information.)
SNMP module (Receives trap information)
Not specified (Receives log, trap, and debugging
information)
Not specified (Receives log, trap, and debugging
information)
Not specified (Receives log, trap, and debugging
information)
TRAP
Enabled/
Severity
disabled
Enabled Debug
Table 1-3, which
DEBUG
Enabled/
Severity
disabled
Enabled Debug