Using The Dadf - Xerox DocuColor 6060 Operator's Manual

S
C A N N E R
4- 6

Using the DADF

1
Remove any paper clips or staples from the documents.
2
Place up to 50 same size or mixed size from 16 to 32 pound (64 to 128 g/m
documents face up in the DADF Tray. Slide the documents to the left until the
green Document Feed Lamp is lit.
3
Ensure that the paper guide is against the document.
4
Extend the DADF Output Tray to accommodate longer length output.
5
Press the Clear All button to clear any previous programming.
6
With the Basic Features screen displayed, enter the required quantity of copies
using the keypad.
If you enter an incorrect quantity, press the C (Clear) button.
7
Select any other required features by touching the button corresponding to the
feature. Some screens require that you touch Save to capture your selections.
8
Press the Start button to begin the scan operation. The original is fed from the
top of the stack to the Document Glass to be scanned then face down to the
DADF output tray on the right.
NOTE:
If the DADF belt is dirty and the original is a thin or transparent
document, background may appear on the copy. This may also occur when copies
are made using the Document Glass. Place a white sheet of paper of the same
size on top of the document being copied to eliminate background until the belt is
cleaned.
6 0 60
D O C U C O L O R O P E R A T O R M A N U A L
2
)