Xerox DocuColor 6060 Operator's Manual page 270

P S
R O B L E M O L V I N G
Problem
The digital press does not
power on.
Prints are not on desired
paper size.
Misregistration of the scan
to print image from the
Document Glass.
Paper is misfed or wrinkles
repeatedly.
Image skew is occurring.
6- 2
• Ensure the power cord is plugged into the receptacle correctly.
• Ensure the power switch inside the front left door is set to the on position.
• Check the GFI circuit breaker switch.
• If the power in your location is working properly, you have tried the suggested
solutions, and the digital press power does not power on, call for assistance.
• Ensure that the proper paper is loaded in the paper trays.
• Select the paper size, tray and weight through the digital press options on
your PC.
• Ensure that the correct weight is selected on the tray.
• Ensure that "Fit to Paper" or an equivalent selection is not selected in your
print driver.
• Go into Tools Mode and adjust registration. Refer to the Tools Mode in the
System Administration Guide.
• If a message appears on the Touch Screen, follow the instructions displayed
and refer to the information in this chapter.
• Ensure the proper paper (refer to the Paper chapter of this manual and The
Recommended Materials List) is loaded correctly and not filled above the
MAX line.
• Turn the paper stack around and/or over in the selected paper tray.
• Remove a few sheets from the top and the bottom of the stack in the paper
tray.
• Fan all four edges of the paper in the selected paper tray.
• Replace the paper in the selected paper tray with paper from a new package.
• Remove any partially fed paper from the trays.
• Ensure the paper you are using had been stored properly.
• Refer to the Skew Adjustment procedure in this chapter.
Suggested solutions
6 0 60
D O C U C O L O R O P E R A T O R M A N U A L